You can follow my day-to-day project updates on social media. It's just that the Synology solution raises the bar, reduces annoyance, and seems to be substantially more capable, making it worth the price premium. They're still workable (and three of them are directly-attached, which is a different beast than a NAS). That doesn't mean I'm rushing to replace my Drobos. Even though I haven't experienced the drive fail/replace cycle with the Synology, there's no doubt that if I needed to add a new RAID NAS device to my network, I'd now choose the Synology over the Drobo. It seems to be a much more capable device. I recommend you splurge on the extra RAM. A five-bay diskless Drobo is $489 on Amazon, where the 2GB four-bay 2GB DS916+ is $549 and the 8GB is $641. The Synology is a little more expensive than the Drobo. Keep that in mind as you read my concluding paragraphs. I haven't had a drive fail yet on the Synology, so I can't really tell how well it will perform a RAID drive swap. But each time that happened, the new drive integrated automatically, and without hassle. Once a red light showed up, I merely popped out the old drive, inserted the new drive, and then worried and obsessed for the 48 or so hours until the new drive was fully integrated. The Drobos have also withstood drive fails relatively elegantly. I've used them for eight years and even the very first one I bought is still in service and working. I'll tell you this: my Drobos have withstood the test of time. I like the Synology, but I don't have as much experience with it as with the Drobos. A share mount takes a second or so, and the directory appears almost immediately. With the Drobo, there's always this little "is it working?" question we tend to think of while waiting for our files to show up. It can take 15-30 seconds (or more) for a directory to show up after a drive has been mounted. One of the frustrations we've become accustomed to dealing with when using our Drobos is the wait for a directory to load after mounting a drive. Granted, I have the model with 8GB of RAM, but still, it's very nice. But because the usability is so much better for the Synology, I have to give the category win to Synology.Įverything about the Synology's performance is crisp. It's a royal pain.īoth vendors have a good-sized selection of apps, so in that regard, it would be a tie. As soon as the CrashPlan console updates, it overwrites the custom config data, and you have to fiddle with it again. To actually control it, you have to go into config files on a remote computer, make some very fiddly changes, and then you get access to CrashPlan.for a while. Even though CrashPlan runs on the Drobo, it runs in headless mode. For example, I enabled the CrashPlan app on the Drobo. Managing the apps is a bit easier on the Synology. Whether you're new to 3D printing or an old hand, ZDNet's 3D Printing Discovery Series will help you understand and get the most out of this amazing, accessible technology. DIY-IT Project: 3D printing discovery series
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |